Panasonic WV-SW598 Installation Manual page 30

Connecting to a network using a PoE+ hub when the temperature is –30 °C {–22 °F} or
less
* When connecting to a network using a PoE+ hub when the temperature is –30 °C {–22 °F} or less, use a 24 V AC power
supply or a tested PoE injector.
Powered speaker
Plug-in power type
microphone
Powered speaker
Plug-in power type
microphone
Recommended total extended
cable length*
IMPORTANT:
• The video monitor used for adjustment is used for checking the adjustment of the angular field of view when installing
the camera or when servicing. It is not provided for recording/monitoring use.
• Depending on the monitor, some characters (camera title, preset ID, etc.) may not be displayed on the screen.
• Use a switching hub or a router which is compliant with 10BASE-T/100BASE-TX or better. (When supplying the power
to a hub or router, apply PoE+ (IEEE802.3at compliant).) It is impossible to supply the power to this product from a
PoE hub or router that is compliant with IEEE802.3af standard.
• If a PoE+ hub is not used, each network camera must be connected to a 24 V AC power supply.
• When using 24 V AC, power supply from a PoE+ hub or router is not required.
30
Video monitor
(for adjustment use only)
RJ45 female connector
(cable coupler)
LAN cable (category 5e or
better, straight)
RJ45 female connector
(cable coupler)
Hub, router
Power supply
(24 V AC)
LAN cable (category 5e or
better, straight)
<Required cable>
LAN cable (category 5e or better, straight)
*
Recommended cable length from the speaker: less than 10 m {32.8 feet}
Recommended cable length from the microphone: less than 1 m {3.28 feet}
LAN cable (category 5e or
better, straight)
PC
Tested PoE injector
Video monitor
(for adjustment use only)