Messages - Sony MZ-B50 Operating Instructions Manual

Messages

If the following error messages flash in the display window, check the chart below.
Error message
BLANKDISC
BUSY
Data Save
DISC ERR
DISC FULL
EDITING
Hi DC in
HOLD
LOW BATT
MEM OVER
MENU
NAME FULL
38
-GB
Meaning/Remedy
• An MD with no recording on it is inserted.
, Insert a recorded MD.
• You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take 2–3
minutes).
• The MD player is recording information (sounds) from the
memory to the disk.
, Wait until this process is completed. Do not expose the player
to any physical shock, nor disrupt power supply.
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
• There is no more space to record on the disc (less than 12 seconds
available).
, Replace the disc.
• You pressed a key on the recorder while editing on the remote
control.
• Voltage of the power supply is too high (The recommended AC
power adaptor or the recommended car battery cord is not used).
, Use the recommended AC power adaptor (not supplied) or the
car battery cord (not supplied).
• The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 25).
• Batteries are weak.
, Replace the dry batteries (pages 6, 32).
• You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording again.
• You pressed a key on the remote control while selecting a menu on
the recorder.
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names during playback or stop.
, Enter the characters within the limit.