Setting The Volume For Each Source; Adjusting The Caller Level; Adjusting The Microphone Level; Adjusting The Ring Tone Level - Alpine X901D Owner's Manual

Setting the Volume for Each Source

Setting item:
Source Volume Setup Radio / DAB / Compressed Media*
iPod Music / iPod Video or AUX*
Setting contents:
-14 to +14 (Initial setting: 0)
*1 Compressed Media is the music data in a USB flash drive (MP3/
WMA/AAC/FLAC).
*2 The item selected in AUX Source Select (iPod Video or AUX) is
displayed. For details, see "Setting the AUX Mode" (page 43).
*3 The source name set in "HDMI Setup" (page 43) and "Setting the
Auxiliary (AUX) Name" (page 43) is displayed.
• Settable source differs depending on the connected device and settings.

Adjusting the Caller Level

You can adjust the volume of the incoming call.
Setting item:
Caller Level
Setting contents:
1 to 11 (Initial setting: 5)

Adjusting the Microphone Level

You can adjust the transmit volume, during the call.
Setting item:
Microphone Level
Setting contents:
1 to 11 (Initial setting: 5)

Adjusting the Ring Tone Level

You can adjust the receive volume, during the call.
Setting item:
Ring Tone Level
Setting contents:
1 to 6 (Initial setting: 3)

Volume Setting

You can change the volume of the sound heard when a button is
touched.
Setting item:
Key Sound
Setting contents:
0 to 6 (Initial setting: 3)

Auto Volume Setting

The volume of the sound heard is raised automatically according to the
noise level by detecting engine noise and road noise.
Setting item:
Auto Volume
Setting contents:
Off (Initial setting) / Low / Middle / High
• The increasing rate of volume becomes large in this order: Low
Middle High.
34
-EN
1
/
2,3 3
/ HDMI* / Bluetooth Audio

Setting Audio Mute On/Off while Backing up

The sound can be muted when the shift gear lever is set to the reverse
(R) position enabling you to easily hear sensors, etc., while reversing
your car.
Setting item:
Mute while backing up
Setting contents:
Off / On (Initial setting)
Off: Does not mute.
On: Mutes when the shift gear lever is set to the reverse (R)
position.

Default Sound Settings

You can restore the Dual HD EQ*/X-OVER*/Time Correction*/MX HD
Level/Rear Speaker/Subwoofer/Subwoofer Level/Subwoofer Phase to
factory settings.
Setting item:
Default Sound Settings
Touch [Set], and the confirmation message appears.
To initialise, touch [OK].
* The setting values that are stored in Preset 1 to Preset 3 cannot be
initialised.