hylite HLF060 Assembly & Fitting Instructions

TROUBLESHOOTING GUIDE

PROBLEM POSSIBLE CAUSE
Lights won't come on • Power not on
• Wired incorrectly
• PIR not detecting movement
• Light conditions too bright
Lights stay on • TIME set too high
• Wired incorrectly
• Frequent changes in heat
are being detected
Lights keep turning • Changes in heat are being
on and off (cycling) detected from a fixed heat source
• Changes in heat are being detected
from a moving object
• Light and heat are being reflected
back onto the sensor
• Sudden temperature changes due
to storms or high winds
Sensing angle and • Angle of PIR sensor head
distance appear is incorrect
incorrect • Sensitivity set too low
Sensor operates • Temperature differences are
differently in hot and affecting the sensitivity of the
cold conditions sensor
Hylite tries to improve its products for the benefit of its
customers. For this reason we reserve the right to make
changes to any product at any time without notice.
Please note that this equipment and its components have
no user serviceable parts. If you experience any difficulties
installing this product please call our helpline or write to:
POSSIBLE SOLUTION
• Turn on indoor switch or check fuse
• Check wiring is the same as wiring diagram
• Adjust the angle and direction of the PIR.
For best results walk across the beam
• Wait until light conditions are darker (at dusk
or under 40 Lux) or turn the LUX control up.
• Turn TIME control towards '-' end
(10 secs to 5 min adjustable)
• Check wiring is the same as wiring diagram
• Check sensing area for possible heat sources
(e.g. air vents, moving vehicles, moving trees)
and re-position the sensor or alter the RANGE
control downwards
• Check the sensing area for air vents, light
fittings or fans and either re-position the
sensor or adjust the aim
• Check the sensing area for moving vehicles,
pedestrians, animals, moving trees and alter
the aim of the sensor accordingly
• Alter aim of the sensor or paint the reflecting
surface with a dull finish
• Turn sensor off until storm passes or install
in a sheltered location
• Adjust the PIR sensor head to alter the sensing
distance and angle
• Turn RANGE knob toward the maximum
• Turn the sensitivity (RANGE) control knob
toward the '+' end for summer (hot conditions)
and toward the '-' for winter (cold conditions).
This compensates for the variations in
temperature
F4 Enterprises Limited
7 Abbey Square, Chester
CH1 2HU.
Tel: 01352 736120
www.f4enterprises.co.uk
LED SECURITY
FLOODLIGHT WITH PIR
For:
HLF060 6W LED Floodlight with PIR
HLF120 12W LED Floodlight with PIR
HLF125 12W LED DUO Dusk to Dawn Floodlight with PIR
Assembly & Fitting Instructions