Watching Tv; General; Wallpaper Setting; Skin Setting - Sharp LC-60UF30H Operation Manual

Watching TV

You can set your TV as you desired by pressing
MENU.

General

For general setting.

Wallpaper setting

You can change the wallpaper of smart home.
In the "Menu" , press a/b to select "General",
1
and then press ENTER.
Press a/b to select "Wallpaper setting", and
2
then press ENTER.
Press c/d to select "Starry Sky" or "Diamond
3
Shine", and then press ENTER.

Skin setting

You can change the skin of smart home.
In the "Menu", press a/b to select "General",
1
and then press ENTER.
Press a/b to select "Skin setting", and then
2
press ENTER.
Press c/d to select "Colour Surge" or "Minty
3
Fresh", and then press ENTER.

Booting state

You can set booting state.
In the "Menu", press a/b to select "General",
1
and then press ENTER.
Press a/b to select "Booting state".
2
Press c/d to select "TV" or "Smart home".
3
• "TV": When turn on the TV, It displays TV mode.
• "Smart home": When turn on the TV, it displays
the smart home.

Language

You can select a language from the menu.
Select from among 3 languages: English, 繁體中文 ,
簡體中文 .
In the "Menu", press a/b to select "General",
1
and then press ENTER.
18
Press a/b to select "Language".
2
Press c/d to select desired language listed
3
on the screen.
NOTE
• Only after restarted the TV, the language of the system can
be changed.

Default input method

For setting input method.
In the "Menu", press a/b to select "General",
1
and then press ENTER.
Press a/b to select "IME setting", and then
2
press ENTER.
Depending on your preferences, press a/b
3
to select desired input method listed on the
screen, and then press ENTER. Press
RETURN to save and exit.
NOTE
• The initial installation of the TV is "IQQI-Chinese Pro".
• If you use any other input method, SHARP can not
guarantee its compatibility with television system.

No signal power off

You can set the TV to automatically power off in about
15 minutes after the TV goes into a state of receiving
no programme signals.
In the "Menu", press a/b to select "General",
1
and then press ENTER.
Press a/b to select "No signal power off".
2
Press c/d to select "Off" or "On".
3
• Five minutes before the power shuts down, the
remaining time displays every minute.

Sleep timer

Auto power-off at a designated time.
In the "Menu", press a/b to select "General",
1
and then press ENTER.
Press a/b to select "Sleep timer".
2
Press c/d to select "Off", "30min.", "60min.",
3
"90min.", "120min." or "150min.". Or you can
press the SLEEP on the remote control unit to
select.
NOTE
• When the time has been set, countdown automatically
starts.
• Five minutes before the preset of time expires, the
remaining time displays each minute.