Getting Started - Monessen Hearth NB18 Installation And Operating Instructions Manual

MAKE SURE YOU HAVE RECEIVED ALL PARTS:
Check your packing list to verify that all listed parts have been received. You should have the following:
• Unvented Gas Log Burner Assembly
• Installation/Operating Instructions
• Ceramic Fiber Logs / Refractory Logs
• Grate Assembly
The following options may be used with the Millivolt controlled heater. These options are not packaged with the log
set.
• Hand Held Remote with Receiver
• Wall Switch with 15' Wire
• Cast Iron Grate and Andirons
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the dealer
from whom you purchased the appliance. Do not attempt to install any part of the appliance unless you have all parts
in good condition.
WHAT YOU WILL NEED FOR INSTALLATION:
You should have the following items available before proceeding with installation:
• External regulator (for propane/LPG and 1/2 lb. natural gas systems only)
• Piping which complies with local codes
• Screwdriver
• Pipe sealant approved for use with propane/LPG (Resistant to sulfur compounds)
• Drill with 5/32 masonry bit
• Manual shutoff valve
81D0107
• Two (2) Plastic Bags Containing Crushed Volcanic Rock
• Two (2) Anchoring Screws
• Rock wool
• On/Off Log Switch Assembly
• Wall Thermostat with 15' Wire
• Hand held Thermostat Remote with Receiver
• Riser Kit
Gloves are recommended when
handling ceramic fi ber logs to prevent
skin irritation from loose fi bers. Logs
are fragile — handle with care.
• Sediment trap (recommended)
• Tee joint.
• Pipe wrench or appropriate size crescent wrench set

GETTING STARTED

5