Superior DRT63STTEN Installation And Operation Instructions Manual page 33

Innovative Hearth Products
DRT63ST Direct-Vent Gas Fireplaces
Combustible Sheathing
Non-Combustible Board
b
Combustible Sheathing
Sheathing Requirements
A
12" (305 mm) 7" (178 mm)
*Dimension "C" is clearance required from fireplace base to surface
(e.g., deck, patio, lanai) as a moisture barrier (not a combustible
clearance) on outdoor side only.
Figure 45 - Sheathing
NOTE: A barrier is
supplied with the
outdoor kit and is
required to be in-
stalled.
In units installed
outdoors this barrier
is constituted by a
safety guard.
barrier: H8249
See kit instructions
506020-49 for further
information.
Figure 47
A
b
C
b C*
6" (152 mm)
Safety
Guard
Glass
Panel
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
B
A
A
Siding
C*
Material
Vinyl 12" (305 mm)
Non-Vinyl 7" (178 mm)
*Dimension "C" is clearance required from fireplace base to surface
(e.g., deck, patio, lanai) as a moisture barrier (not a combustible
clearance) on outdoor side only.
Figure 46 - Exterior Clearances
SAFETY GUARD INSTALLATION INSTRUCTIONS
Note: This procedure requires two people.
Step 1. If the fireplace is on, turn it OFF. Allow it to cool completely.
BEFORE CONTINUING, FIREPLACE MUST BE OFF AND
COLD!
Step 2. Remove the two existing screws from the top of the Front
Glass Panel.
Note: After removing screws, one person must hold the
glass panel in place (to prevent it from falling forward and
breaking), while another person completes the installation.
Step 3. Insert the back lip of each Mounting Bracket (without the
hole) under the bottom edge of the Glass Panel.
Step 4. Attach one Spring Nut Clip (with straight edge facing front
and down) to the front lip of each Mounting Bracket, and
then align the holes.
Step 5. Slide the openings in the bottom edge of the Safety Guard
over the Spring Nut Clips.
Step 6. Align the holes in the top of the Safety Guard with the
holes in the top of the Front Glass Panel. Use a Phillips
screwdriver to replace the two screws previously removed.
Align the holes in the lower front of the Safety Guard
with the holes in the Clips and Brackets. Use a Phillips
Front
screwdriver to install the two supplied Washer Screws.
Installation Instructions
900355-01, 07/2015
Overhang
Siding
A
Exterior Minimum Clearances
A b
35-1/2" (902 mm) 6" (305 mm)
35-1/2" (902 mm) 6" (305 mm)
Siding
Trim
C*
33