Table of Contents
Advertisement
5.3 The Overview of the Connection Area
The [Table 5-4] shows the inner structure of the 3.6 kWh All In One when the front case cover
is removed (Section 5.1).
On the front part of the inside of the system,
the INVERTER circuit is blocked by the safety
shield, thus leaving the space for battery
installation (Region A) available.
The BMS circuit board is shown on the
upper part of the Battery region, in which
the four battery connector is located. A
battery power connection terminal is shown
on the lower part of the device
Australia (Eng.) 05/2015. Rev1.1
Inside Front View
[Table 5-4: Front and Rear view of All in One]
5. Electrical Connections
Inside Rear View
On the rear part, the INVERTER shield is
shown, but other connection terminals
are not.
27
Advertisement
Table of Contents
