MSI RX480 Neo2 MS-7151 User Manual page 48

M S-7151 ATX M ainboard
supported by your operating system. To find out which version to use, consult
the vendor of your operating system. Settings: [1.4], [1.1].
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Set-
tings are: [Enabled]
[Disabled]
Boot Sequence
Press <Enter> and the following sub-menu appears:
1st/2nd/3rd Boot Device
These items allow you to set the sequence of boot devices where BIOS
attempts to load the operating system.
Boot From Other Devices
Setting the option to [Yes] allows the system to try to boot from other
devices if the system fails to boot from the 1st/2nd/3rd boot device. Set-
tings are: [Yes], [No].
MSI Reminds You...
Available settings for "1st/2nd/3rd Boot Device" vary depending
on the bootable devices you have installed. For example, if you
did not install a floppy drive, the setting "Floppy" will not show up.
Hard Disk Drives/Removable Drives
These items allow you to specific the boot devices where BIOS attempts to
load the operating system.
3-10
Shows a still image (logo) on the full screen at boot.
Shows the POST messages at boot.