If, however, automatic connection is not possible, you can connect the
subwoofer to the soundbar manually:
1. Switch the soundbar on by pressing the
remote control.
2. Now press the Pair button at the back of the subwoofer for approximately
two seconds.
The PAIR LED at the back of the subwoofer flashes orange when the
subwoofer is in discover mode. Both devices are connected when the LED
glows orange.
Select audio source
Use the SOURCE button on the soundbar or the OPTICAL, AUX, BT and HDMI
ARC buttons on the remote control to select the desired audio source: AUX, BT,
HDMI ARC or optical.
The operating mode selected will be indicated by the following coloured LED
operating lights
Operating light
Red
Green
Orange
Blue
Adjusting the volume
Use the VOL+/VOL– buttons on the soundbar or the remote control to set the
desired volume:
+
Increase volume
–
Reduce volume
The volume can be turned off completely by pressing the MUTE button on the
remote control.
Press the MUTE button again to restore the audio output.
AFTER SALES SUPPORT
1300 884 987
AUS
6
:
flashes
HDMI
Select audio source
button on the device or on the
constantly on
Standby
AUX
Optical
Bluetooth
www.medion.com.au
AUS
23