OPERATING PROCEDURE
8. Removing the booster heater
(1) Remove the intake grille.
(2) Remove the front panel.
(3) Remove the insulation panel.
(4) Remove the green connector of the heater.
9. Removing the indoor heat exchanger
(1) Remove the intake grille.
(2) Remove the front panel.
(3) Remove the insulation panel.
(4) Remove the 6 screws of the top panel and
remove the top panel.
(5) Remove the swing louver.
(6) Remove the electrical parts box.
(7) Remove the 3 screws of the drain pan support
and remove the drain pan support.
(8) Remove the 4 screws of the indoor heat
exchanger to remove it.
10. Removing the drain pan
(1) Remove the intake grille.
(2) Remove the front panel.
(3) Remove the insulation panel.
(4) Remove the top panel.
(5) Remove the swing louver.
(6) Remove the electrical parts box and the drain
pan support.
(7) Remove the pipe support.
(8) Remove the drain pan.
PHOTOS
Photo 10
Photo 11
Drain pan
support
Electrical
parts box
Photo 12
34
Swing louver
Booster heater
Screws
Screws
Indoor heat
exchanger
Screws
Pipe support
Screws
Indoor heat exchanger
Drain pan
Drain pan support