What Is Hott 5P; Operation 5P; Battery Installation; Charging Batteries - GRAUPNER S1001 Operating Instructions Manual

ADJUSTBLE STICK LENGTH
◎
The control stick is consisted of 2pc of stick levers and it allows you to adjust the control stick's
length as you want.
1. Hold the lever"B"and turn the lever"A"
counter clockwise The lock will be released.
2. Turn the lever"B"and adjust the control
stick's length as you want. Turn the lever"A"
clockwise, then the lever"A"and"B"are
interlocked and fixed.
ADJUSTBLE STICK TENSION
◎
The T5/mz-10 offers adjustable tension on the throttle, aileron, elevator and rudder sticks.
1. Remove the battery cover and battery form the transmitter.
2. Unscrew the six Philips head screws that hold the transmitter's rear cover and remove the
rear case.
3. Using a Philips screw driver, adjust the stick tension screw for the desired control.
Clockwise to tighten and counter clockwise to loosen.
Model 1
Aileron tension
Model 2
Aileron tension
Elevator tension
Lever"A"
Lever"B"
Elevator tension
Rudder tension
Rudder tension
WHAT IS HoTT
◎
HoTT stands for Hopping Sequence Telemetric Technology, it
is Graupner/SJ's unique telemetry technology in 2.4GHz signal
protocol that supports Bi directional data transmission gives user
real-time information on things like user model's RPM,
Voltage, Temperature, User programmed warning, and etc.
The use of up to 75 channels ensures extreme operating reli-
ability and immunity to external interference thanks to optimized
frequency hopping broad channel sequence.
OPERATION
◎

1. Battery Installation

Optional NiCd or NiMH 1.2-volt AA rechargeable 4-cell batteries can be used. A battery connecter
is on the inside of the transmitter for convenient recharging. Graupner/SJ offers rechargeable
NiCd, NiMH batteries, part number S22331.
Remove the battery cover and install the battery pack ensuring
the polarity of the battery connecter.

2. Charging Batteries

The included charger is designed to recharge your batteries at a rate of 150mA. Do not use this
charger for equipment other than Graupner/SJ transmitters that use 4-cell battery packs. The
charging plug polarity may not be the same and equipment damage can result. During the charging
operation, the charger's temperature is slightly elevated. This is normal.
CAUTION
Charge only rechargeable batteries. Non-rechargeable
batteries may burst causing injury to persons and/or damage
to property. Never leave charging batteries unattended
All Graupner/SJ charge jacks are center-pin negative. This is the opposite of many chargers.
Before using a charger make sure the connector is center-pin negative. This can be done using a
voltmeter. Also unlike conventional radio systems that use 8 cells to power the transmitter, the T5/mz-
10 uses 4 cells. This is due to the electronics being more efficient. When charging, be sure to use a
charger designed for a 4-cell 4.8-volt battery pack when charging the transmitter.

3. Turn on the transmitter

Leave the trainer switch to Normal position and turn on the transmitter.
The T5/mz-10 is compatible with all current Graupner/SJ aircraft receivers (R Series)
Graupner/SJ
Transmitter Charge Jack Polarity
Normal
Teacher
Pupil
5