Summary of Contents for GRAUPNER S1001
- Page 1 OPERATING INSTRUCTION Prior to use, please read this manual thoroughly. Keep this manual in a convenient place for quick and easy reference.
-
Page 2: Table Of Contents
Frequently Asked Questions (on - Customer support the web pages referenced below), your hobby dealer, or the Graupner/SJ Service Center. Due to unforeseen changes in production procedures, the information contained in this manual is - Internet sales site subject to change without notice. - Page 3 Graupner/SJ. For up-to-date product literature, visit http://www.openhobby.com and click on the support tab for this product. 5 channels radio control set with Graupner/SJ HoTT 2.4 GHz technology(Hopping Intellective Telemetry) The use of up to 75 channels ensures extreme operating reliability and immunity to external interference.
- Page 4 TRANSMITTER CONTROL IDENTIFICATION ◎ Antenna TX Handel RF Trainer Switch 5 Channel Switch Dual Rate Switch Neck Strap Lug Battery Cover Rudder and Throttle and Elevator Stick Aileron Stick Throttle Trim Elevator Trim Power Switch Aileron Trim Rudder Trim Mode Button Direction Button Bind LED...
-
Page 5: What Is Hott 5P
Never leave charging batteries unattended All Graupner/SJ charge jacks are center-pin negative. This is the opposite of many chargers. Before using a charger make sure the connector is center-pin negative. This can be done using a voltmeter. -
Page 6: Binding
6. Dual Rate 4. Binding The T5/mz-10 offers a dual rare function on aileron, elevator and rudder. When the DUAL RATE You must bind the receiver to the transmitter before the receiver will operate. Binding teaches the receiver the specific code of the transmitter so that it will only connect to it’s corresponding transmitter. SWITCH is in the up position, 100% travel is achieved on the aileron, elevator and rudder chan- nels. -
Page 7: Failsafe
Press & hold the MODE button for over 2 sec and release the button. The Graupner/SJ logo turns solid red, indicating the hold mode has been set. If you lose connection, all channels hold the last given command. -
Page 8: Country Setting
ER SWITCH to PUPIL position. Press & hold the MODE button and switch on the transmitter. The Graupner/SJ logo repeats to blink a single red with a single beep, indicating that you set PUPIL 1. Insert the supplied shunt connector into the DATA socket at the back of the transmitter and switch Mode. -
Page 9: Range Testing 9P
◎ The signal reception of the receiver is not good The transmitter repeats that Graupner/SJ logo blinks 3 times red with 3 times beeps. The signal reception of the transmitter is not good For more information on the latest firmware and the related software, please refer to the The transmitter repeats that Graupner/SJ logo blinks 4 times red with 4 times beeps. - Page 10 This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with - Product(s): Graupner/SJ T5/mz-10/mz-10 Transmitter the instructions, may cause harmful interference to radio communications. However, there Item Number(s): is no guarantee that interference will not occur in a particular installation.
- Page 11 Caution • This equipment’s aerial must be at least 20 cm from any person when the system is in use. We therefore do not recommend using the equipment at a closer range than 20cm. • Ensure that no other transmitter is closer than 20cm from your equipment, in order to avoid adverse effects on the system’s electrical characteristics and radiation pattern.