Kenmore 587.1522 Use & Care Manual page 19

Solutions to Common Dishwashing Problems
Dishware Stained or Discolored
• Tea and coff ee can stain cups. Remove
the stains by hand washing in a solution
of 1/2 cup (120 ml) bleach and one quart
(1L) of warm water. Rinse thoroughly.
• Iron deposits in water can cause a yellow
or brown fi lm. A special fi lter installed
in the water supply line will correct this
problem. (See Removing Spots and Film).
• Aluminum utensils can leave gray/black
marks when they rub against other items.
Load Properly.
• Certain high acid foods can cause
discoloration of stainless steel and plastics
if allowed to sit for a long period. Use
the Rinse Only cycle or rinse by hand if
not operating dishwasher at once.
• Mixing stainless steel and silver utensils
in silverware basket can cause pitting of
the stainless steel blades. Avoid mixing
stainelss steel and silver.
Etching
• Using too much detergent especially in
soft or softened water causes damage
that looks like a fi lm but cannot be
removed.
• Adjust the amount of detergent based
on the water hardness. (Check Detergent
Chart).
• Lower the water temperature by selecting
the Normal Cycle.
Detergent Left in Cups
• Detergent may be old. Discard and use
fresh detergent.
• Be sure the dish load doesn't spray from
entering the detergent cup.
• Chcek to see if cycle has been completed.
• Make sure items do not prevent the
detergent dispenser from opening.
Vapor at Vent
• Water vapor escapes fromt he vent
during the drying part of cycle. This is
normal.
• Spilled rinse aid can cause foam and
lead to overfl owing. Wipe up any spills
with a damp cloth.
• Check to see that dishwasher is level. (See
Installation Instructions).
Normal Sounds You Will Hear
• Normal sounds include water fi ll, water
circulation and motor sounds.
• There is a noticeable change in sound
when the wash action switches between
the lower and middle spray arm. This is
normal since each spray arm has it's own
sound.
• It is normal for the dishwasher to pause
(no sound) when the wash action is
switching between the lower and middle
spray arms.
Water in Bottom of Tub
• Water left in the tub bottom after the
cycle is complete is not normal. If water
remains in the bottom of the tub, the
dishwasher may not be draining properly.
(See Dishwasher Does not Drain Properly).
Dishwasher Won't Run
• Check to see if circuit breaker is tripped
or if a fuse is blown.
• Make sure water supply is turned on.
• Check to see if cycle is set correctly. (See
Operating Instructions).
• Is dishwasher set for Delay Start Option?
• Make sure door is closed and latched.
19