Features At A Glance - Kenmore 587.1522 Use & Care Manual

Features At A Glance

Cup Shelves
(on some models)
Bowl Tines
Middle Spray Arm
Lower Spray Arm
Self-Cleaning Filter
Overfi ll
Protector
Detergent
Dispenser
NOTE
The dishwasher is programmed to remember your last cycle so you do not have to
reset each time. To start the dishwasher using the same cycle and options selected
on the previous wash, just press the START/CANCEL pad.
Your dishwasher cleans by spraying a mixture of hot water and detergent through the
spray arms against soiled surfaces. First, the dishwasher fi lls with water covering the
fi lter area. Water is then pumped through the spray arms. Soil Particles go through
and across the fi lters, and down the drain as the water is pumped out. This series of
steps are repeated as needed. The number of water fi lls will vary with the cycle being
used.
GETTING STARTED
1. Load dishwasher (See Preparing and Loading Dishes).
2. Add detergent (See Dishwasher Dispenser & Detergents).
3. Add rinse aid, if needed (See Rinse Aid).
4. Close Door to Latch.
5. Select desired CYCLE (See Cycle Chart). The indicator light above the pad will glow
when selected.
6. Select desired OPTION (See Energy Option). The indicator light above the pad
will glow when selected.
7. Run hot water faucet nearest dishwasher until water is hot. Turn water off .
8. To start, press START/CANCEL pad.
Nozzle or Spray Arm
Features may vary according to model
Top Rack
8
Tub Gasket
Serial Label
(located on right
side of tub)
Bottom Rack
Silverware Basket
Glass Trap
Heating Element
Rinse Aid
Dispenser