Datalogic QuickScan QBT2400 Quick Reference Manual page 44

LED and Beeper Indications
Indication
a
Green Spot
flashes
momentarily
a Except when in sleep mode or when a Good Read LED Duration other than
00 is selected
Programming Mode
the reader is in Programming Mode.
Indication
Label Program-
ming Mode Entry
Label Program-
ming Mode Rejec-
tion of Label
Label Program-
ming Mode Accep-
tance of Partial
Label
Label Program-
ming Mode Accep-
tance of
Programming
Label Program-
ming Mode Cancel
Item Entry
36
Description
Upon successful
read of a label, the
software shall turn
the green spot on
for the time speci-
fied by the config-
ured value.
- The following indications ONLY occur when
Description
A valid program-
ming label has been
scanned.
A label has been
rejected.
In cases where
multiple labels
must be scanned to
program one fea-
ture, this indication
acknowledges each
portion as it is suc-
cessfully scanned.
Configuration
option(s) have been
successfully pro-
grammed via labels
and the reader has
exited Program-
ming Mode.
Cancel label has
been scanned.
LED
N/A
LED
LED blinks
continu-
ously
N/A
N/A
N/A
N/A
Beeper
N/A
Beeper
Reader sounds
four low fre-
quency beeps.
Reader sounds
three times at
lowest fre-
quency and cur-
rent volume.
Reader sounds
one short beep
at highest fre-
quency and cur-
rent volume.
Reader sounds
one high fre-
quency beep
and 4 low fre-
quency beeps
followed by
reset beeps.
Reader sounds
two times at low
frequency and
current volume.
QuickScan™ QBT2400