Table of Contents
Advertisement
2.4
FIRMWARE UPDATES
All OSD2244 units will be shipped with the latest firmware already installed. The Type- A USB port is
used for any firmware updates. To enable the OSD2244 for firmware updates, switch 4 will need to be
toggled to the 'on' position before unit is powered on. Upon completion of firmware updating, toggle
switch 4 to the 'off' position and power the unit on again.
Upgrading the OSD2244 latest firmware consists of three steps;
1.
Install FLIP (Flexible In-System Programmer) on user PC
2.
Install the driver on user PC for the USB port of OSD2244 target unit
3.
Copy firmware (from CD or other multimedia) to local disk and program new firmware to
target unit.
2.4.1
INSTALLING FLIP
Create a new folder : c:\osd on users PC as the destination folder for FLIP.
•
Execute JRE_Flip_Installer_3.4.2.exe from CD and follow steps outlined below;
•
PAGE 18
OPTICAL SYSTEMS DESIGN
FIGURE 15: OSD2244 USB CONNECTOR
OSD2244 OPERATOR MANUAL
Type-A USB Port
DOC ID: 10108207
Advertisement
Table of Contents
