Gps Data - Nokia C5–00 User Manual

position. To select the location from the
map, select Select from
position information manually, select
Enter manually.
Edit — Edit or add information to a saved
landmark (for example, a street address).
Add to category — Add a landmark to a
category in Landmarks. Select each
category to which you want to add the
landmark.
Send — Send one or several landmarks to
a compatible device. Your received
landmarks are placed in the Inbox folder
in Messaging.
You can sort your landmarks into preset
categories, and create new categories. To
edit and create new landmark categories,
open the categories tab, and select
Options Edit categories.
>

GPS data

Route guidance
Select Applications
>
and Navigation.
Start the route guidance outdoors. If
started indoors, the GPS receiver may not
receive the necessary information from
the satellites.
Route guidance uses a rotating compass
on the device display. A red ball shows the
direction to the destination, and the
approximate distance to it is shown inside
the compass ring.
Route guidance is designed to show the
straightest route and the shortest
distance to the destination, measured in
a straight line. Any obstacles on the route,
such as buildings and natural obstacles,
© 2010 Nokia. All rights reserved.
map. To enter the
GPS data
>
are ignored. Differences in altitude are not
taken into account when calculating the
distance. Route guidance is active only
when you move.
To set your trip destination, select
Options Set destination
>
landmark as the destination, or enter the
latitude and longitude coordinates.
To clear the destination set for your trip,
select Stop navigation.
Trip meter
Select Applications
>
and Trip distance.
The trip meter has limited accuracy, and
rounding errors may occur. Accuracy can
also be affected by availability and quality
of GPS signals.
To turn trip distance calculation on or off,
select Options
>
calculated values remain on the display.
Use this feature outdoors to receive a
better GPS signal.
To set the trip distance and time and
average and maximum speeds to zero,
and to start a new calculation, select
Options > Reset. To set the trip meter
and total time to zero, select Restart.
Positioning
and a
GPS data
>
Start or Stop. The
63