Pioneer PRO-720HD Service Manual page 68

PRO-720HD, PRO-620HD, PRO-520HD
SPECIAL NOTES
•
Picture Adjustments
MOVIE or GAME mode may not selected when receiving
RGB input.
GAME mode setting:
• All signals output from the Projection Monitor will be unaffected.
Only the original output signal is sent through the output jacks.
Picture Quality setting:
• The COLOR, TINT, and SHARPNESS settings may not be changed
when receiving RGB input.
• When RLS is LVL1 or LVL 2, CONTRAST, BLACK LVL and COLOR
cannot be adjusted.
• When picture quality has been adjusted, the user mode data will
be overwritten with the new settings.
Other Picture Quality setting:
• Only the COLOR TEMP settings may be changed when receiving
RGB input.
PURECINEMA adjustment:
• Normally, this function should be set to "HQ" (High Quality), however,
occasionally this setting may cause slight syncopation problems
with the audio track. If you are bothered by this, select "STD"
(Standard) or "OFF". If "OFF" is selected, normal progressive signal
processing is performed.
•
Sound Adjustments
BASS, TREBLE and BALANCE are SPEAKER mode settings,
which can only be adjusted when mode is NORMAL.
Surround Mode setting:
• This function cannot be used when the SPEAKER mode is CENTER
IN or when the SPEAKER mode is OFF and AUDIO OUT mode is
FIXED.
• The surround effect cannot be obtained with mono sound.
• In some cases, the surround effect may be minimal.
•
Connection with Receiver (1)
Speaker and AUDIO OUT Setting:
• After the speaker mode is set to CENTER IN, the volume of the
center speaker should be controlled from this monitor.
• If AUDIO OUT is set to VAR and the sound is distorted,
lower the Monitor volume.
•
Connection with Receiver (2)
System Mode ON:
• The input cannot be switched even if you press the Input selector
button of the remote control unit.
• On the sub-picture of a SPLIT screen, only the input signal from
the antenna can be displayed.
• The SEARCH screen function will not be operable.
• No signal will be output from the AUDIO OUTPUT terminal.
• Setting SYSTEM MODE ON will cause RGB input signals to not be
displayed.
•
Changing Screen Mode
• When 1080i component signals or RGB signals are input, SCREEN
MODE will be limited to FULL.
250