Pioneer DEH-P4000UB Operation Manual page 62

(~I_"s_t_a_lIa_t_io_"
)
(~ E_"---",,9~li_sh_)
(----:c=-:o=-:"_"--=-e--=-c-=--t i.::...::,"
SL9
--=-th::....::...e=------=-u::....::..."i=-=.t
_~) (~ E_"---"'!9~Ii..::.-sh~)
• Control signal is output through blue/white cable
when this unit is powered on. Connect it to an ex-
ternal power amp's system remote control or the
vehicle's auto-antenna relay control terminal (max.
300 mA, 12 V DC). If the vehicle is equipped with a
glass antenna. connect it to the antenna booster
power supply terminal.
• Never connect blue/white cable to external power
amp's power terminal. Also, never connect it to
the power terminal of the auto antenna. Other-
wise. battery drain or malfunction may result.
• IP-BUS connectors are color-coded. Be sure to
connect connectors of the same color.
• Black cable is ground. This cable and other
product's ground cable (especially, high-current
products such as power amp) must be wired sepa-
rately. Otherwise, fire or malfunction may result if
they are accidentally detached.
No ACe position ACC
position
• When this unit is Installed in a vehicle without
ACC (accessory) position on the ignition switch,
red cable must be wired to the terminal that can
detect the operation of the ignition key. Otherwise.
battery drain may result.
• Use this unit in other than the following condi-
tions could result in fire or malfunction.
-Vehicles with a 12-volt battery and negative
grounding.
-Speakers with 50 W (output value) and 4 ohm
to 8 ohm (impedance value).
• To prevent short-circuit. overheating or malfunc-
tion, be sure to follow the directions below.
- Disconnect the negative terminal of the battery
before installation.
-Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring. wrap adhesive
tape around them where they lie against metal
parts.
- Place all cables away from moving parts, such
as gear shift and seat rails.
-Place all cables away from hot places, such as
near the heater outlet.
-Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
-Cover any disconnected cable connectors with
insulating tape.
- Do not shorten any cables.
-Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
- Use a fuse of the rating prescribed.
-Never wire the speaker negative cable directly
to ground.
-Never band together multiple speaker's nega-
tive cables.
Screw
Fastening the front panel
If
you do not plan to detach the front panel,
the front panel can be fastened with supplied
screw.
2. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
- - t - f
&0
,&a@)
3. Tighten two screws on each side.
• Use either truss screws (5 mm
x
8 mm) or
flush surface screws (5 mm x 9 mm), depend-
ing on the shape of screw holes in the bracket.
ofD / Screw
o
DIN Rear-mount
1. Extend top and bottom of the trim
ring outwards to remove the trim
ring. When reattaching the trim ring,
push the trim ring onto the unit until
it clicks. (If the trim ring is attached
upside down, the trim ring
will
not
fit properly.)
• It becomes easy to remove the trim ring if the
front panel is released.
QJg
Factory radio mounting bracket