Rheem AP16697 Use & Care Manual page 17

HIGH TEMPERATURE
*Note: If screen is
dimmed press any
button and release
to brighten the
display before
performing desired
action.
DISPLAY
BEEP
INSTANCE
High temperature mode will
allow the water temperature to
be set above 140 degrees F.
Press the DOWN arrow to
change setting then press
SELECT.
PRESS TO
– NO
SELECT
- YES
Display mode is used to change
the temperature displayed
from Fahrenheit to Celsius.
Press the UP and DOWN arrow
at the same time to change.
CHANGE
Beep mode is use to turn all
the audible alarms on and off.
Press the UP and DOWN arrow
at the same time to change.
In this mode, error alarms and
water sensor detection alarms
will not occur.
CHANGE
Instance number is used to
identify the water heater if
additional water heaters or
devices are connected to a
joint home control system.
The number may be changed
from 1 to 15 to identify this
water heater.
SCROLL
17