Kenwood TK-3302 Service Manual Supplement page 4

TK-3302
Notes:
• You must install the KCT-53U driver in the computer to
use the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the fi rst time,
plug the KCT-53U into a USB port on the computer with
the computer power ON.
2. When the POWER is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
transceiver enters PC mode.
When data is read from the transceiver, the red LED
lights.
When data is written to by the transceiver, the green LED
lights.
Notes :
• The data stored in the personal computer must match
Model Name and Model Type when it is written into EE-
PROM.
• Do not press the [PTT] key during data transmission or
reception.
3-3. KPG-22/KPG-22A Description
(PC programming interface cable : Option)
The KPG-22/22A is required to interface the transceiver
with the computer. It has a circuit in its D-sub connector
(KPG-22: 25-pin, KPG-22A: 9-pin) case that converts the RS-
232C logic level to the TTL level.
The KPG-22/22A connects the SP/MIC connector of the
transceiver to the RS-232C serial port of the computer.
3-4. KCT-53U Description (USB adapter : Option)
The KCT-53U is a cable which connects the KPG-22A to a
USB port on a computer.
When using the KCT-53U, install the supplied CD-ROM
(with driver software) in the computer. The KCT-53U driver
runs under Windows 2000 or XP.
3-5. FPU (Programming Software) Description
The FPU is the programming software for the transceiver
supplied on a CD-ROM. The software on this disk allows a
user to program the transceiver transceivers via Program-
ming interface cable (KPG-22/22A).
3-6. Programming with PC
If data is transferred to the transceiver from a PC with the
FPU, the data for each set can be modifi ed.
Data can be programmed into the EEPROM in RS-232C
format via the SP/MIC jack.
In this mode the PTT line operate as TXD and RXD data
lines respectively.
List of FPU for transceiver
Model Type
TK-3302 K2,K3,M2
4
REALIGNMENT
FPU
KPG-118D(K)
PC
FPU
Tuning cable
(E30-3216-05)
PC
D-SUB D-SUB
(25-pin) (9-pin)
KPG-22
Transceiver Transceiver
Fig. 1
4. Wireless Clone Mode
4-1. Outline
"Wireless Clone Mode" copies the transceiver data to
another transceiver.
The dealer can copy the transceiver data to another trans-
ceiver even without the use of a personal computer.
4-2. Example
The transceiver can copy the programming data to one or
more transceivers via RF communication.
The clone source and clone target/s must be in wireless
clone mode.
KPG-22 or KPG-22A or
KPG-22A+KCT-53U
Illustration is KPG-22
+
Gray
SP
–
Gray/Black
+
1.5D-XV Lead wire
MIC
1.5D-XV Shield wire –
PC PC
USB
KCT-53U
KPG-22A
KPG-22A
Transceiver