Advertisement
Installation
The Fixing Kit should contain: 1 Drilling Template, 3 Screws, 3
Rawlplugs, 1 Mounting Bracket and 1 Hexagon Key.
Wall Mounted Operation
WARNING: This heater must not be located
immediately below a fixed socket outlet.
The plug must be accessible after heater installation.
Suggested Fixings
SOLID BRICK/BLOCK: No. 8 Rawlplug inserts, 6mm drill bit.
PLASTERBOARD - If possible locate studding and use No. 8
woodscrews directly into the wood, otherwise M5 rawlplug intersets
are suitable.
NOTE: FOR OTHER WALL TYPES (e.g. Timber frame and hollow
concrete) SEEK SPECIALIST ADVICE.
1. Select the position for the heater ensuring there is
clearance from any furniture and fittings of at least 150mm
above the heater, 50mm below and 25mm each side.
Curtains must not be closer than 150mm from the top of the
heater.
2. Position the drilling template provided on the wall ensuring it
is level. Mark the position of the relevant holes on the wall at
the edge of template. Before drilling check that the distance
between the hole centres is correct, 340mm for the 400W
Model and 540mm for 800W models (see Fig. 2).
Operation
IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and instructions have been read carefully.
OPERATION
Models DYLP40, DYLP80, DYLP80TI
Turn the heater on using the switch on the right side of the heater
- the switch will be illuminated.
MODEL WITH TIMER - (see Fig. 3)
DYLP80TI
The switch on the side of the heater turns the heater on.
Note: This switch must be in the "on" position before the heater
will operate.
(See Fig. 2)
130mm
25mm
Drilling Holes
Fig. 2
Bracket
3. Drill the wall at the three marked positions and fit the wall
plugs.
Ensure template has been removed.
4. Fix two No. 8 screws to the top two holes leaving 3mm of the
screw exposed. Hang the heater on the screws.
5. Fit the bottom bracket, found in the fixing kit, in the slot at the
base of the heater and screw the bracket to the wall.
Test that the heater is now securely fixed to the wall.
Digital Timer Operation
IMPORTANT Remember to observe all safety warnings when
operating the heater on auto setting unattended or attended.
The timer allows you to select 'MANUAL ON' , 'AUTO' or' MANUAL
OFF' operation mode by pressing the Input / Output button marked
'I/O' until the required mode appears at the bottom of the timer
display.
'MANUAL ON' mode allows power to the heater uninterrupted by
the timer settings. The heat selector switch will control the output.
'MANUAL OFF' mode switches off all heater operation completely.
'AUTO' mode allows the low wattage panel heater to switch ON
and OFF according to the timer settings (see 'Setting Programs'
section below).
12/24 Hour Mode Either 12 or 24 hour modes can be used.
Press the S (Set) and P (Program) buttons simultaneously to switch
between 12 and 24 Hour mode.
Initial Operation (Fig. 3)
For initial use, plug the timer into a regular household power point
and turn the power on. Clear all current information by pressing the
R button with a sharp object such as a pencil. The timer is now
ready to be set up for use.
130mm
340mm - 400W
540mm - 800W
420mm
150mm
95mm
25mm
50mm
Advertisement
