Panasonic EY7410 Operating Instructions Manual page 13

Cordless drill & driver
Table of Contents

Advertisement

ONLY FOR U. K.
VI
. ELECTRICAL PLUG
INFORMATION
FOR YOUR SAFETY PLEASE READ
THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a moulded
three pin mains plug for your safety and
convenience.
A 3 amp fuse is fitted in this plug.
Should the fuse need to be replaced please
ensure that the replacement fuse has a
rating of  amp and that it is approved by
ASTA or BSI to BS16.
Check for the ASTA mark
mark
on the body of the fuse.
If the plug contains a removable fuse cover
you must ensure that it is refitted when the
fuse is replaced.
If you lose the fuse cover the plug must
not be used until a replacement cover is
obtained.
A r e p l a c e m e n t f u s e c o v e r c a n b e
purchased from your local Panasonic
Dealer.
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET OUTLET
I N Y O U R H O M E T H E N T H E F U S E
SHOULD BE REMOVED AND THE PLUG
CUT OFF AND DISPOSED OF SAFELY.
T H E R E I S A D A N G E R O F S E V E R E
ELECTRICAL SHOCK IF THE CUT OFF
PLUG IS INSERTED INTO ANY 1 AMP
SOCKET.
If a new plug is to be fitted please observe
the wiring code as shown below.
If in any doubt please consult a qualified
electrician.
EY7410(EU).indb
13
IMPORTANT:
The wires in this mains lead are
coloured in accordance with the
following code:
Blue: Neutral
Brown: Live
As the colours of the wire in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows.
The wire which is coloured BLUE must be
connected to the terminal in the plug which
is marked with the letter N or coloured
BLACK.
The wire which is coloured BROWN must
be connected to the terminal in the plug
which is marked with the letter L or coloured
or the BSI
RED.
Under no circumstances should either
of these wires be connected to the earth
terminal of the three pin plug, marked with
the letter E or the Earth Symbol
How to replace the fuse: Open the fuse
compartment with a screwdriver and
replace the fuse and fuse cover if it is
removable.
This apparatus was produced to BS800.
- 1 -
Fuse Cover
.
2006/07/19
17:27:54

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents