Sharp XG-P10XU Service Manual page 33

No. Adjusting point
30 Color 1. Feed the gray-only RGB
irregularity
correction gain
(in case of
colorirregularity)
31 Checking and 1.The adjustment condition of
readjustment of
white balance
2. A digital television does
32 Color system 1. Receive the color bar sig-
performance
check
33 Video system 1. Receive the monoscope
performance
check
34 Audio system
performance
check
35 RGB 1. Receive the RGB signal.
performance
check
36 Off-timer
performance
check
37 Thermistor 1. Heat the thermistor using a
performance
check
38 Automatic 1. Receive the PHASE check
synchronization
39 Keystone
correction
performance
check
40 Factory settings
Adjusting conditions
color signal. (XGA 60Hz)
each item is as mentioned
in the following.
RGB input:Refer to No.13
VIDEO input:Refer to No.23
DVD input:Refer to No.28
compensation adjustment
by using "CR-OFFSET" or
"CB-OFFSET".
nal.
pattern signal.
dryer.
pattern signal.
33
Adjusting procedure
» Adjust R4215 to minimize the right-hand and left-
hand color irregularity.
» Make sure that a white balance is the best condi-
tion.
» Make this adjustment after finishing the above ad-
justment.
» In the process mode and select L1. Check the color
and tint.
» In the process mode and select L2. Check the pic-
ture, brightness and sharpness.
» In the process mode nad select L3. Check the bass,
treble and balance.
» In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
» In the process mode and select OFF. Make sure that
the off-timer starts with "5" (minutes), counts down
each minute in 1 second, and turns off the set at "0".
» Make sure the "TEMP" is displayed.
» Call the VGA/S-VGA/XGA mode and make sure
that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
» Make sure the keystone correction functions well.
» Make the following settings.
Process Remote controller
adjustment setting
S4 "Factory setting 4"
XG-P10XU