Using Nightshot Mode; Using Nightframing; Zooming The Lens; Turning The Conversion Lens On And Off - Sony CYBER-SHOT DSC-F717 Pocket Manual

A P G S C
OCKET UIDE TO THE ONY YBER
2. Photograph a white sheet of paper or other white
surface under the same light you'll be photograph-
ing in.
3. Press the white balance one push button next to
WHT BAL on the lens to store the new white
balance setting. The white balance indicator
flashes rapidly. (Don't move the camera as it does.)
When it stops, the setting is stored. If it continues
to flash slowly, the setting has not been set, so try
again, or use auto mode.
4. When finished, repeat Step 1 to reset white balance
to auto mode (no icon).

Using NightShot Mode

1. With the mode dial set to full auto, program AE, or
moving image, set the NightShot/NightFraming
switch to NIGHTSHOT.
2. Press the shutter button halfway down to set focus
and exposure, then all of the way down to take the
picture.
3. When finished, set the NightShot/NightFraming
switch to the center position marked by the green
dot.

Using NightFraming

1. With the mode dial set to full auto, program AE, or
clip motion, set the NightShot/NightFraming
switch to NIGHTFRAMING.
2. Press the shutter button halfway down to set focus
and exposure, then all of the way down to take the
picture.
3. When finished, set the NightShot/NightFraming
switch to the center position marked by the green
dot.

Zooming the Lens

To zoom the lens with the buttons on the lens, press
the W side of the zoom button to widen the angle of
view and the T side to enlarge subjects.
To zoom by rotating the zoom ring on the lens, set
the focus switch on the lens to AUTO/ZOOM .

Turning the Conversion Lens On and Off

1. Set the mode dial to SET UP, press MENU, and
display the CAMERA 1 tab.
2. Press the down point on the control button to
select CONVERSION LENS, then press the right
point to display choices.
3. Press the up or down point on the control button
to select ON or OFF, then press the center point to
set it.
T S C W S
HE HORT OURSES EB ITE AND
- F717
SHOT
O - D P B
N LINE IGITAL HOTOGRAPHY OOKSTORE

Turning Digital Zoom On and Off

1. Set the mode dial to SET UP to display the set up
screen with the CAMERA 1 tab selected.
2. Press the right point on the control button to
activate the menu, the down point to select DIGI-
TAL ZOOM, then the right point to display choices.
3. Press the up or down point on the control button
to select ON (the default) or OFF, then press the
center point to set it.

Using Auto Flash

With the camera in any still image record mode or clip
motion in moving images, press the up point on the
control button to cycle through the available flash
modes (see below). When no icon is displayed, the
mode is auto.

Setting the Flash Level

1. With the mode dial set to clip motion or any still
image record mode other than full auto, press
MENU.
2. Press the right or left point on the control button to
highlight the flash level icon, then press the up
point to highlight your choice—HIGH, NORMAL,
or LOW.
3. Press the shutter button to take a picture, or press
MENU to hide the menu.

Turning Red-eye Reducing Flash On and Off

1. Set the mode dial to SET UP and select the CAM-
ERA 1 tab.
2. Press the right point on the control button to
activate the menu, the down point to select RED
EYE REDUCTION, then the right point to display
choices.
3. Press the up or down point on the control button
to select ON or OFF, then press the center point to
set it.

Using Fill Flash

With the camera in any still image record mode, press
the up point on the control button to cycle through the
available flash mode until the forced flash icon is
displayed.

Choosing Twilight Portrait Mode

1. With the mode dial set to SCN, press MENU, then
press the right or left point on the control button to
highlight SCN on the menu.
2. Press the up or down point on the control button
to select the TWILIGHT PORTRAIT icon.
11
:// . .
HTTP WWW SHORTCOURSES COM