Adjusting The Throttle Cable Free Play - Yamaha 2002 TW125 Supplementary Service Manual

ADJUSTING THE THROTTLE CABLE FREE PLAY

EAS00058
ADJUSTING THE THROTTLE CABLE FREE
PLAY
NOTE:
Prior to adjusting the throttle cable free play, the
engine idling speed should be adjusted.
1. Check:
S throttle cable free play a
Out of specification ! Adjust.
Throttle cable free play
(at the flange of the throttle grip)
3 X 5 mm
2. Adjust:
S throttle cable free play
NOTE:
When the motorcycle is accelerating, the accel-
erator cable 1 is pulled.
Carburetor side
a. Loosen the locknut 2 on the decelerator
cable.
b. Turn the adjusting nut 3 in direction a or b
to take up any slack on the decelerator cable.
c. Loosen the locknut 4 on the accelerator
cable 1 .
d. Turn the adjusting nut 5 in direction a or b
until the specified throttle cable free play is
obtained.
Direction
a
Direction
b
e. Tighten the locknuts.
NOTE:
If the specified throttle cable free play cannot be
obtained on the carburetor side of the cable, use
the adjusting nut on the handlebar side.
Handlebar side
a. Slide back the rubber cover 1 .
b. Loosen the locknut 2 .
c. Turn the adjusting nut 3 in direction a or b
until the specified throttle cable free play is
obtained.
–19–
CHK
ADJ
Throttle cable free play
is increased.
Throttle cable free play
is decreased.