Table of Contents
Advertisement
Do not disassemble the product; any mark of tampering will compromise
the warranty validity.
We recommend following the instructions of the hardware user guides for
a correct wiring of the product. The product has to be supplied with a stabilized voltage
source and the wiring has to be conforming to the security and fire prevention
regulations.
The product has to be handled with care, avoiding any contact with the
pins because electrostatic discharges may damage the product itself. The same cautions
have to be taken for the SIM, checking carefully the instruction for its use. Do not insert
or remove the SIM when the product is in power saving mode.
The system integrator is responsible of the functioning of the final
product; therefore, care has to be taken to the external components of the module, as
well as of any project or installation issue, because the risk of disturbing the GSM
network or external devices or having impact on the security. Should there be any doubt,
please refer to the technical documentation and the regulations in force.
Every module has to be equipped with a proper antenna with specific
characteristics. The antenna has to be installed with care in order to avoid any
interference with other electronic devices and has to guarantee a minimum distance
from the people (20 cm). In case of this requirement cannot be satisfied, the system
integrator has to assess the final product against the SAR regulation.
1. The unit does not provide protection from lightning and surge. For outdoor
installation use outdoor nonmetallic case safety approved according UL 50. Additionally
you should provide protection from lightning and over voltage according National code.
2. Be sure the use of this product is allowed in the country and in the
environment required. The use of this product may be dangerous and has to be avoided
in the following areas: Where it can interfere with other electronic devices in
environments such as hospitals, airports, aircrafts, etc. Where there is risk of explosion
such as gasoline stations, oil refineries, etc. It is responsibility of the user to enforce the
country regulation and the specific environment regulation. Do not disassemble the
product; any mark of tampering will compromise the warranty validity. We recommend
following the instructions of the hardware user guides for a correct wiring of the
product. The product has to be supplied with a stabilized voltage source and the wiring
has to be conforming to the security and fire prevention regulations. The product has to
be handled with care, avoiding any contact with the pins because electrostatic
discharges may damage the product itself. Same cautions have to be taken for the SIM,
checking carefully the instruction for its use. Do not insert or remove the SIM when the
product is in power saving mode. The system integrator is responsible of the functioning
of the final product; therefore, care has to be given to the external components of the
unit, as well as of any project or installation issue, because the risk of disturbing the GSM
network or external devices or having impact on the security. Should there be any doubt,
please refer to the technical documentation and the regulations in force. Every unit has
ELTRONIKA sp. z.o.o.
Ul. Warszawska 41 lok.7
05-092 Łomianki
info@eltronika.com
www.eltronika.com
64
- Polska: +48 22 751 97 44
- Česká republika: +420 228 880 487
- Slovensko: +421 904 540 707
Advertisement
Table of Contents
