Operation - Basic Door Answer Function - AT&T Door Phone Controller Installation And Operation Manual

The Forced Disconnect
Time-out option does not apply
when setting options (unless 2
minutes elapse without a
Touch-Tone selection)
Operation – Basic Door Answer Function
Visitor Presses Door Speaker Button
Answering a Call from the Door Speaker
4. To exit option selection mode, press "##3" on the
telephone keypad (you will hear 2 beeps). Hang up the
phone.
5. Set position 8 of the AT&T Door
switch back to the OFF position.
When a visitor presses the door speaker push button, the
AT&T Door Phone Controller will signal the telephone
equipment inside your home or building to ring, and activate a
door-bell/chime device (optional). Any additional presses on the
door speaker push button will be ignored until the option
selected ring/chime duration has expired (with the exception
that a confirmation tone will still be sent to the speaker when
the door button is pressed).
The person inside the building can simply answer the ringing
phone and establish two-way communications with the door
speaker. To open the door, the person inside the building either
enters the Door Code on the telephone's keypad or presses
the customer provided door-unlock push button. Either of these
actions will activate the customer provided electric door strike
plate device.
Phone Controller DIP
Installation — Home/Residential 3-7