Option Selection - AT&T Door Phone Controller Installation And Operation Manual

Option Selection

Refer to Appendix B for a
detailed explanation of each of
these options.
Any or all options may be
reselected in any order.
The final step of the installation procedure is selecting options
for your AT&T Door Phone Controller. The selection of these
options must be done while in the Option Selection Mode. This
mode lets you control such things as:
Delay Before Door Ajar Call-Back
Ring/Chime Cadence
Ring/Chime Duration
Door Unlock Code
Door Unlock Duration
Enable Door Code
Door Ajar Mode
Forced Disconnect Time-Out
Reset Options to Factory Defaults
Follow the steps below to select options for the Door Phone
Controller.
1.
Select Option Selection Mode by setting position 8
of the Door Phone Controller DIP switch to the ON
position (see Figure 1-1).
2. Once the DIP switch has been set, you must make con-
nection to the door speaker by "hook-flashing" the
phone (within 5 seconds) and entering "##3" on the
telephone keypad (option selection mode is active as
soon as you hear a distinctive dial tone).
3. Use Table 3-1 to make each option selection.
Installation — Home/Residential 3-5