EnGenius ENH500 User And Setup Manual page 3

Hide thumbs Also See for ENH500:

Next go to the WDS Link Settings from the menu heading Wireless

Set the Security to AES

Enter an AES Passphrase at least 8 characters long (you will use the same passphrase on Unit B)

Select Enable from the Mode box – this will allow you to enter a MAC Address of the other unit.

Type in Mac Address of Unit B (next time we will do vice versa and use the MAC address of Unit A)

Click Accept

(Be aware of Save/Reload: under the Status heading, you can apply multiple changes at once but

they won't take effect until you click Save & Apply from this section, don't do this just yet...)

Go to IP Settings from the menu heading System

As the Router in the network has an address of 192.168.2.1 we need to give the Engenius unit an IP

address that is in the same network range but does not clash with anything else.

Here I've used

192.168.2.100

The Subnet Mask should be 255.255.255.0

If desired, put in the Router's address for the Default Gateway (our example is 192.168.2.1)

Click Accept