KTM 350 EXC-F 2015 Owner's Manual page 100

18 SERVICE WORK ON THE ENGINE
–
Remove screws
M00203-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
M00204-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
M00205-10
–
Remove the oil filler plug
engine oil.
Engine oil
M00206-10
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (

. Take off the oil filter cover with the O-ring.

out of the oil filter housing.

with the O-ring from the clutch cover and fill up with
1.2 l (1.3 qt.)
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 96)
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 112)
formance
98

.
p. 112)