Table of Contents
Advertisement
MACHINE OPERATION
PRE-RUN MACHINE INSPECTION
Do a pre-run inspection to find possible problems
that could cause poor performance or lost time from
breakdown. Follow the same procedure each time to
avoid missing steps.
NOTE: See maintenance section for pre-run
machine inspection checklist items.
STARTING MACHINE
NOTE: Perform pre-run machine check before
operating machine.
FOR SAFETY: Before starting machine, make
sure that all safety devices are in place and
operating properly.
1. Disconnect the battery charger.
2. Close the cover.
3. Turn or install a new burnishing pad as needed.
4. The operator should be on the pedal platform
with their left foot on the operator presence
pedal. The throttle pedal must be in the neutral
position.
5. Turn the machine power on by turning key
switch clockwise to the "ON" position.
6. Check the position of the Directional Control
Switch to make sure the machine will travel in
the direction intended.
7. Press the Drive Reset Switch.
8. Press lightly on the throttle pedal with right foot.
3-11
Downloaded from
www.Manualslib.com
86306300 CHARIOT BURNISHER 11/09/07
manuals search engine
OPERATING THE MACHINE
1. Lower or raise deck by pressing burnishing head
switch.
2. The pad motor will only run when the burnishing
head is lowered to within 2 inches of the floor.
3. The pad pressure is adjusted using the knob at
right of panel. The operator monitors the amp
draw using the meter located on the control
panel and ensures that the needle remains in
the "blue" operating range.
To prevent possible damage to the floor surface,
always keep the machine moving while the pad
is spinning.
4. When the head is down and the machine is
propelled, the pad motor runs.
5. Return the machine to the battery charger when
the battery light indicator meter indicates
discharged batteries
EMERGENCY STOP PROCEDURES
1. Release the throttle pedal by lifting right foot.
2. Turn machine power off with key switch, by
turning key switch counterclockwise.
3. If an electrical problem is suspected, push in
emergency stop button. This will also engage
the parking brake and cause the machine to
stop immediately.
Advertisement
Table of Contents
