Maintenance And Care; Switching The Appliance Off; Cleaning The Appliance; Avoiding Mould And Unpleasant Odours - Hotpoint FFU4DG X MTZ Operating Instructions Manual

Refrigerator/freezer combination
Table of Contents

Advertisement

! To avoid blocking the air circulation inside the freezer
compartment, it is advisable not to obstruct the ventilation holes
with food or containers.
! Do not open the door during freezing.
! If there is a power cut or malfunction, do not open the freezer
door. This will help maintain the temperature inside the freezer,
ensuring that foods are conserved for at least 9 -14 hours.
!To maximise space inside the freezer, all drawers [with the
exception of the bottom drawer] can be removed from their
positions and the food placed directly on the racks/glass shelves
supplied [where present].
*
Hidden Shelf
There is wireshelf inside the freezer compartment located between
the upper and lower freezer baskets. To Access wire shelf, remove
the basket of the upper freezer door. Wire shelf may be removed
out of the freezer by holding up from the front edge.
It is recommended to use the wire shelf only for long term storage.
*
ICE DEVICE
After pouring water in the special ice cups, place them in their
places in the ice device. After about 2 hours, the ice cubes will
be ready. In order to get the ice cubes, it will be sufficient to turn
the two buttons to the right. The ice cubes will fall in to the tray
below, ready to be used.
If you need more storage space, the ICE DEVICE may be taken out
by pushing the nail on the top of the ice device.
! To close the refrigerator door to pay attention to the vertical bracket
position (see figure)

Maintenance and care

Switching the appliance off

During cleaning and maintenance it is necessary to disconnect
the appliance from the electricity supply:
1. Press the ON/OFF button to switch off the appliance.
2. Pull the plug out of the socket.
! If this procedure is not followed, the alarm may sound. This alarm
does not indicate a malfunction. To restore normal operation,
hold the ON/OFF button down for more than two seconds. To
disconnect the appliance, follow points 1 and 2 above.

Cleaning the appliance

• The external and internal parts, as well as the rubber seals may
be cleaned using a sponge that has been soaked in lukewarm
water and bicarbonate of soda or neutral soap. Do not use
solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water and
soap or dishwashing liquid. Rinse and dry them carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner set
on medium power. The appliance must be switched off and
the plug must be pulled out before cleaning the appliance.

Avoiding mould and unpleasant odours

• The appliance is manufactured with hygienic materials which
are odour free. In order to maintain an odour free refrigerator
and to prevent the formation of stains, food must always be
covered or sealed properly.
• If you want to switch the appliance off for an extended period
of time, clean the inside and leave the doors open.
Replacing the light LED *
Thanks to the powerful light it emits, the new dual LED lighting
system offers a clear view of all foods, with no shadowy areas.
If the LEDs need to be replaced, please contact the Technical
Assistance Service.

Precautions and tips

! The appliance was designed and manufactured in compliance
with international safety standards. The following warnings are
provided for safety reasons and must be read carefully.
*
Varies by number and/or position, available only on certain models.
GB
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents