Adjust Doors - KitchenAid KBSN602ESS Installation Manual

Adjust Doors

Door Height Adjustment
Use the following steps to adjust the door height, up or down,
after the doors have been leveled.
1. Open the freezer or refrigerator door. Locate the bottom hinge
and remove the door stop screw.
Stainless Models
Remove the door stop screw from the bottom side of the
hinge with a ³⁄₈" open end wrench.
A
A. Bushing
B. Door stop screw
Overlay Models
Remove the 2 door stop screws: one from the bottom side
using a ³⁄₈" open end wrench and one from the top side using
a ⁵⁄₃₂" hex key.
A
A. Door stop screw from bottom
B. Door stop screw from top (110°)
2. Remove the locking plate as shown.
3. Turn the bushing located underneath the bottom of the hinge
using a ¹⁄₂" open end wrench. Turning the bushing to the left
will lower the door. Turning the bushing right will raise the
door.
20 20 20 20 20 20
B C
C. Locking plate
B
4. After adjusting, check the doors to make sure they are even
at the top and bottom. If the doors are not even, continue to
turn the bushing to adjust the door height.
5. Replace the locking plate.
6. Turn the bushing slightly to align the hinge and locking plate
screw holes.
7. Replace the door stop screw or screws and tighten.
IMPORTANT: Do not place the door stop screw in the 130°
position on Overlay Series models unless the custom panels
have been routed on the hinge side. See "Overlay Series Door
Panel and Cabinetry Clearance."
8. Recheck to make sure the doors are aligned and even.
Door Swing Adjustment
1. Check that the refrigerator door can open freely. If the door
opens too wide, remove the door stop screw or screws
(depending on your model) from the bottom hinge. See "Door
Height Adjustment" earlier in this section.
2. Hold the door open to a position that is less than 90°.
3. Replace the door stop screw or screws in the bottom hinge
and tighten.
A
A. 130°
B. 110° (Overlay series)
Door-to-Door or Door-to-Refrigerator Trim Adjustment
1. Loosen, but do not remove, the four Torx
mounting screws. Remove and discard the two ¹⁄₄" hex-head
mounting screws.
2. Adjust the top hinge of either door to align it with the other
door or the refrigerator trim.
®†
3. Tighten the four Torx 27 flat-head mounting screws to a
torque of approximately 100 inch-pounds (11.3 Nm).
B
A. Torx ® 27 flat-head mounting screws
¹⁄₄
B. " hex-head mounting screws
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
B C
C. 90°
®† 27 flat-head
A