The remote control
Insert the battery
1
Push the catch in the direction shown by
arrow
to remove the holder.
2
Insert the battery with the "+" marked side
facing up.
3
Return the holder to its original position.
•
When the battery (CR2025) has run out, replace
it with a new one. (The battery lasts about one
year, depending on the frequency of use.)
If the remote control unit fails to work even when
it is operated near the camera-recorder's remote
control sensor, the battery has run out.
•
Keep the battery out of the reach of children.
Turn on/off the camera
While pressing the lock release button, move the
POWER switch to ON or OFF.
Turn on the camera:
Turn off the camera:
The mode lamp (CAMERA) goes out.
•
Energy-saving mode
ON:
OFF: Does not switch OFF the camera.
See the setup menus, POWER SAVE
(Page 111) for details.
Remote control usable range
The distance between the remote control and the
unit's remote control sensor: Within approx. 5 m
Angle: Approximately 15° upward,
approximately 10° downward,
approximately 15° leftward, or
approximately 15° rightward
(Except when optional accessories are
attached)
Remote control
sensor
•
Mode lamp
POWER switch
Set the POWER switch to the
ON position while pressing the
lock release button.
The CAMERA lamp lights (red),
and the camera enters recording
standby mode.
Lock release button
27