Parts List; Installation Instructions - Charmglow 18EF010GAA Homeowner's Operating Instructions

Position your completed Wood Mantel close to its
final location. Make sure you can access the back of
the Fireplace, as your Electric Fireplace Insert will be
installed from the back.
Using a Phillips head screwdriver, remove the screws
and the metal mounting brackets attached on either
side of the fireplaces center opening. Next unpack
the Electric Fireplace Insert carefully. Position insert
behind fireplace with front facing the wood mantel.
With the help of an adult assistant, lift the Insert and
gently slide it into the opening in the mantel until the
flange is flush against the inside of the fireplace. Make
sure insert is centered left and right in the opening. Be
careful when placing insert and adjusting, bottom of
insert could scratch the finish of the wood base/hearth
of your fireplace. Re-attach the mounting brack-
ets with the Phillips head screwdriver, and supplied
screws. DO NOT OVER TIGHTEN.
With the help of an assistant, carefully lift completed
unit and place it with the front facing out in the final
location you have chosen for your fireplace. Make
sure to secure the electrical cord before lifting or mov-
Emberbed
Heater/Blower Assembly
Mechanical Thermostat Switch
Knob for Heater Temperature control
Brightness Dimmer Switch
Knob for Brightness Control
Main Power Switch - Red Toggle
Heater On/Off Switch - Red Toggle
E-12 Light Bulb Sockets
Control Panel Circuit Board
Circuit Board - 3 Buttons Remote
Front Projection Screen
Flame Generator Drive Motor
Flame Generator/Spinner
Decorative Brick Panels
Remote Control - 3 Buttons
IN STA LLATI ON I NST R U CT I ONS
PA RT S L IST
Part Name
ing completed fireplace. When choosing a final loca-
tion, make sure you will have clear access to a ground-
ed electrical outlet.
Read and follow all instructions in this manual before
operating your new fireplace.
INSERT
MOUNTING
BRACKET
ELECTRIC
FIREPLACE
INSERT
18"
E-3
Figure 2
REAR VIEW OF FIREPLACE
23" 28" 33"