Syntax SV266AD User Manual page 61

IRQ/Event Activity Detect
Scroll to this item and press <Enter> to view the following screen:
Phoenix – AwardBIOS CMOS Setup Utility
VGA
LPT & COM
HDD & FDD
PCI Master
PowerOn by PCI Card
Modem Ring Resume
RTC Alarm Resume
x Date (of Month)
x Resume Time (hh:mm:ss)
IRQs Activity Monitoring
↑ ↓ → ← : Move
Enter : Select
F5:Previous Values
This item opens a submenu that enables you to set events that will resume
the system from a power saving mode.
VGA (Off)
When set to On, the system power will resume the system from a power
saving mode if there is any VGA activity.
LPT & COM (LPT/COM )
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the serial ports, or the parallel port.
HDD & FDD (ON)
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the hard disk drive or the floppy
diskette drive.
PCI Master (OFF)
When set to Off, any PCI device set as the Master will not power on the
system.
PowerOn by PCI Card (Enabled)
Use this item to enable PCI activity to wakeup the system from a power
saving mode.
Modem Ring Resume (Disabled)
Enable Modem Ring-in to resume the system.
RTC Alarm Resume (Disabled)
When set to Enabled, additional fields become available and you can set the
date (day of the month), hour, minute and second to turn on your system.
When set to 0 (zero) for the day of the month, the alarm will power on your
system every day at the specified time.
IRQ/Event Activity Detect
[OFF]
[LPT/COM]
[ON]
[OFF]
[Enabled]
[Disabled]
[Disabled]
0
0 0 0
[Press Enter]
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults
41
Item Help
Menu Level
F1:General Help
F7:Optimized Defaults