ElliptiGO 2015 Owner's Manual page 16

The Riding Position (Folding Steering Column)
To place the folding steering column into the riding
position, follow these steps:
1. Open both collar quick releases.
2. Slide collar back along steering column to clear
pivot.
3. Rotate steering column upward until it is straight
in-line with the steering base.
4. Rotate the collar so index mark is aligned with the
"OPEN" marking on the right side of the steering
column base.
5. Slide the collar down over the pivot until the
bottom of the collar contacts the mating flange on
steering base. ENSURE THAT THERE IS NO GAP
BETWEEN THE BOTTOM OF THE COLLAR AND THE
Steering column shown in
STEERING BASE MATING FLANGE!
locked riding position
6. Rotate the collar clockwise until index mark on the
collar is aligned with "LOCK" marking on the back
of the steering column base.
7. Close both collar quick releases to lock the
steering column into the riding position.
Note: Refer to Section III. 1. A. for the procedure for
proper tightening and adjustment of quick release
mechanisms.
WARNING! ENSURE THE "MAX EXTENSION"
MARK ON THE STEERING EXTENDER IS BELOW THE
COLUMN QUICK RELEASE! Raising the steering
extender so that the "MAX EXTENSION" mark is
above the top of the column could result in the
steering extender breaking during operation or
being pulled out of the column, causing the rider
to fall. Never use your ElliptiGO when the "MAX
EXTENSION" mark is visible above the column.
Bike Owner's Manual
16