Power Inverter - Dodge caliber 2012 User Manual

ELECTRONICS
• Simultaneously press and hold both the Homelink button you want to program and
the hand-held transmitter button.
• Continue to hold both buttons and observe the indicator light. The Homelink
indicator will flash slowly and then rapidly after Homelink
frequency signal from the hand-held transmitter. Release both buttons after the
indicator light changes from slow to rapid.
• Press and hold the programmed HomeLink
NOTE:
• If the indicator light stays on constantly, programming is complete and the garage
door (or device) should activate when the HomeLink
• To program the two remaining HomeLink
remaining button. DO NOT erase the channels.
Using HomeLink®
• To operate, press and release the programmed HomeLink
now occur for the programmed device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting, etc.,). The hand-held
transmitter of the device may also be used at any time.
• Your motorized door or gate will open and close while you are programming
the universal transceiver. Do not program the transceiver if people or pets are
in the path of the door or gate.
• Do not run your vehicle in a closed garage or confined area while
programming the transceiver. Exhaust gas from your vehicle contains Carbon
Monoxide (CO) which is odorless and colorless. Carbon Monoxide is
poisonous when inhaled and can cause you and others to be severely injured
or killed.

POWER INVERTER

54
® button and observe the indicator light.
® button is pressed.
buttons, repeat each step for each
®
WARNING!
• A 115 Volt, 150 Watt AC power
inverter is located on the front of the
center console.
• This outlet can power cellular phones,
electronics and other low power
devices requiring power up to 150
Watts.
NOTE: The power inverter is designed with
built-in overload protection. If the power
rating of 150 Watts is exceeded, the power
inverter will automatically shut down. Once
the electrical device has been removed
from the outlet, the inverter should
automatically reset. If the power rating
®
has received the
®
button. Activation will
®