Universal Garage Door Opener (Homelink ) - Dodge caliber 2012 User Manual

ELECTRONICS
Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle and close all the doors.
• Cycle the ignition switch between LOCK and ON and then back to LOCK four
times, ending up in the LOCK position (do not start the engine).
• Press the power door UNLOCK switch to unlock the doors. A single chime will
indicate that programming is complete.
Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flashing Lights With Lock
• The turn signal lights flashing, when the doors are locked or unlocked, feature can
be turned on or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER
(HomeLink )
®
• HomeLink replaces up to three hand-held transmitters that operate devices such
®
as garage door openers, motorized gates, lighting or home security systems. The
HomeLink ® unit is powered by your vehicles 12 Volt battery.
• The HomeLink ®
designate the three different HomeLink
• The HomeLink
®
52
buttons that are located in the overhead console or sunvisor
indicator is located above the center button.
channels.
®
Before You Begin Programming HomeLink®
• Be sure that your vehicle is parked
outside of the garage before you begin
programming.
• For more efficient programming and
accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink ®
system.