Cleaning And Maintenance - vitapur VWD1006W Use & Care Manual

TEMP
Adjusting the Temperature (Cold water only)
By turning the thermostat at the back of the unit, the temperature can be adjusted.
Turn the dial clockwise between the high (cool) and low (colder) levels until the
desired temperature is reached. If the water dispenser is not dispensing water, there
could be a possible ice build up due to the thermostat being set too cold. If this
High
Low
happens, unplug the dispenser overnight and then reset. Set thermostat to high,
COLD WATER
slowly increasing based on your use and need for cold water.
Dispensing Hot Water
The Kettle Feature dispensing system on this unit is designed to save energy and money.
Conventional hot water dispensing systems operate 24/7 regardless of water usage. The
(on demand) Kettle Feature activates the hot water system "only" when the Kettle Feature (red) button is activated
delivering steaming hot water in less than 3 minutes.
To stop/cancel the Kettle Feature during a cycle, simply press the Kettle Feature button a second time and the red LED
light will stop flashing.
IMPORTANT NOTE: Your Vitapur® water dispenser is designed with a special "safety" feature (float switch
mechanism) that controls activation/operation of the Kettle Feature hot water tank heating system. If no water is
present and/or low water levels are detected inside the internal water reservoir, activation/operation of the Kettle
Feature hot water heating system is not possible. Likewise, if the hot water heating system is operational and
water is being drawn simultaneously causing internal water levels to drop below the established minimal level set
point, hot water tank operation is automatically suspended. To reactivate the hot water heating system, you must
replenish your water supply.
Child Resistant Safety Switch
To prevent hot water from being dispensed accidentally and possible harming
a child, the hot water dispensing button can only be operated when the child
resistant safety switch is activated. To dispense hot water, push the child safety
switch sideways, (in the direction of the arrow located on the switch) from
right to left, then depress the hot water button until the desired amount of hot
water is dispensed. Upon releasing the hot water button, the child safety lock
FIG. 7. Child Resistant Safety Switch
automatically returns to the locked position. (figure 7)
DANGER: The hot water is heated to approximately 194˚ F / 90˚C. Temperatures above 125˚ F / 52˚ C can cause
severe burns from scalding. DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
Cleaning Kit

CLEANING AND MAINTENANCE

Like most appliances, your water dispenser requires periodic maintenance for
maximum efficiency and performance and must be cleaned on a regular basis
(i.e. every 4 months). To maintain a hygienic environment within your water
dispenser and prevent potential formation (growth) of bacteria, we strongly
recommend regular cleaning. A cleaning kit is available through our Customer
Service Department at 1-866-253-0447 or can be ordered on line at
www.greenwayhp.com. Please see "Initial Product Cleaning Procedure" and
Available online at
follow instructions.
www.greenwayhp.com
4 5