Table of Contents
Advertisement
Adjusting the front seats
First read and observe the introductory information and safety warn-
ings
on page 50.
Adjusting a seat in a forward/back direction
›
Pull the lever
» Fig. 36
up and push the seat into the desired position.
1
›
Release the lever
and push the seat until the lock clicks into place.
1
Adjusting height of seat
›
To lift the seat, pull or pump the lever
›
To lower the seat, push or pump the lever
Adjusting the angle of the seat backrest
›
To adjust the angle of the backrest, relieve any pressure from the seat backrest
(do not lean on it) and turn the handwheel
Front seat heating
Fig. 36
Control elements at the seat
» Fig. 36
upwards.
2
downwards.
2
» Fig.
36.
3
Fig. 37
Rocker switch for front seat
heating
First read and observe the introductory information and safety warn-
ings
on page 50.
The seat backrests and seats can be heated electrically.
›
By pressing the rocker switch in the position 1 or 2 switch on the front seat
heating to 25 % or 100 % of its power output
›
To switch off the heating shift the rocker switch into the horizontal position.
WARNING
If, as an occupant, you have a subdued pain and/or temperature sensitivity,
e.g. through medication, paralysis or because of chronic illness (e.g. diabetes),
we recommend not to use the seat heating. This can lead to burns on the
back, the posterior and the legs which are difficult to heal. If the seat heating
is used, we recommend to make regular breaks in your journey when driving
long distances, so that the body can recuperate from the stress of the jour-
ney. Please consult your doctor, who can evaluate your specific condition.
CAUTION
Do not kneel on the seats or otherwise apply pressure at specific points to
■
avoid damaging the heating elements for the seat heaters.
Do not use the seat heaters if the seats are not occupied by persons or if ob-
■
jects, such as a child seat, bag, etc., are fastened or stored on them. A fault of the
heating elements in the seat heating can occur.
Do not clean the seats using moisture
■
Note
The seat heating should only be switched on when the engine is running. This
■
has a significant effect of saving on the battery capacity.
If the on-board voltage drops, the seat heating is switched off automatically, in
■
order to provide sufficient electrical energy for the engine control
tomatic load deactivation.
» Fig.
37.
» page
150, Seat covers.
» page
168, Au-
Seats and stowing
51
Advertisement
Chapters
Table of Contents
