Ignition Switch - Toyota rav 4 2006 Instruction Manual

Ignition switch

"START"—Starter motor on. The key
will return to the "ON" position when
released.
For starting tips, see page 305 in Section
3.
"ON"—Engine on and all accessories
on.
This is the normal driving position.
"ACC"—Accessories such as the radio
operate, but the engine is off.
If you leave the key in the "ACC" or
"LOCK" position and open the driver's
door, a buzzer will remind you to remove
the key.
140
'06 Rav4_U (L/O 0601)
"LOCK"—Engine is off and the steering
wheel is locked. The key can be re-
moved only at this position.
You must push in the key to turn it from
"ACC" to the "LOCK" position. The selec-
tor lever must be in the "P" position be-
fore pushing the key.
Vehicles with engine immobilizer
tem—Once you remove the key, the en-
gine immobilizer system is automatically
set. (See "Engine immobilizer system" on
page 15 in Section 1- 2.)
When starting the engine, the key may
seem stuck at the "LOCK" position. To
free it, first be sure the key is pushed all
the way in, and then rotate the steering
wheel slightly while turning the key gently.
Approximately five hours after the engine
is turned off, you may hear sound coming
from under the floor around the driver's
seat for several minutes. This is normal
operation and does not indicate a malfunc-
tion. (See "Leak detection pump" on page
ix.)
It is not a malfunction if the needle on all
meters and gauges move slightly when the
key is turned to the "ON" or "START"
position.
I n f o r ma t i o n P r o v i d e d b y :
NOTICE
Do not leave the key in the "ON"
position if the engine is not running.
The battery will discharge and the
ignition could be damaged.
sys-
2005 RAV4 from Jan. '06 Prod. (OM42620U)