Table of Contents
Advertisement
STEP 1
Fasten front stabilizer (37) with
2 Allen bolts (83) from the underside
of stabilizer. Fasten Rear stabilizer (82)
with 2 Allen bolts (83).
STEP 2
I. Carefully lift the Handlebar Post (18)
until it is vertical. Put the front plastic
cover (90) into the Handlebar post (18).
Connect the Upper Computer Cable (35)
and the Lower Computer Cable (36).
II. Fit the Allen Bolt (34),spring washer (22) and
curved washers (33) and align handlebar post so it
is straight. Then tighten the Allen bolts fully.
STEP 3
Apply grease from packet to the axle
then slide footplate support bar (28R)
onto the axle.
Fasten the footplate to the axle by plac-
ing spacer (59) on the end of the axle
and attach with Allen bolt (23), spring
washer (22) and flat washer (21).
Once secure attach plastic cover (56) to
the footplate with screw (55).
Repeat for left side
83
82
55
56
6
84
37
18
33
22
34
35
90
36
84
59
21
22
23
83
28R
Advertisement
Table of Contents
