Table of Contents
Advertisement
Blanking Adjustment
Notes
• When the RGB signal is input, the adjustable range of the vertical shift
(V SHIFT) can be set to WIDE or NARROW by pressing the POSITION
+/– keys.
• When the video signal is input, V SHIFT is automatically fixed to
NARROW and the adjustable range of the vertical shift will become
narrower than that of the RGB signal.
3
Press the MEMORY key to save the adjustment data.
Resetting to the initial preset position
The position of the picture of the video signal can be reset to the initial
preset position by pressing the RESET key in RGB SHIFT adjustment
mode. (The position of the picture of signals other than the video signal
cannot be reset.)
If the displayed picture is larger than the screen, cut off the excess parts.
1
Press the BLKG key.
2
Press the POSITION +/– keys to select the part to be adjusted.
• When you press the + key, the position cycles through the following
order:
TOP n BOTTOM n LEFT n RIGHT n TOP ...
• When you press the – key, the position cycles in reverse order.
B L K G A D J
T O P
T : 5 0
B : 5 0
ADJ:
L : M A X
NEXT:
R : 5 0
3
Adjust with the arrow keys.
• Press the V and v keys to adjust the TOP and BOTTOM positions.
• Press the B and b keys to adjust the LEFT and RIGHT positions.
4
Press the MEMORY key to save the adjustment data.
Note
When you connect multiple input sources to the projector, such as when
using the switcher, adjust the picture size, picture shift and blanking for
each input connector.
+ –
25
Projecting
Advertisement
Table of Contents
