Ventilation Requirements; Technical Information; Technical Data - Zanussi ZFC41400WA User Manual

A
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. Connect the wire coloured green and
yellow to the terminal marked either with the
letter "E" or by the earth symbol
coloured green and yellow.
2. Connect the wire coloured blue to the
terminal either marked with the letter "N" or
coloured black.

Technical information

Technical data

Height
Width
Depth
Rising time
Voltage
Frequency
The technical information are situated in the
rating plate on the external side of the appliance
and in the energy label.
www.zanussi.com
B
C
D
E
or
mm
mm
mm
Hours
Volts
Hz
3. Connect the wire coloured brown to the
terminal either marked with the "L" or
coloured red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure
over the outer sheath.
Make sure the electricity supply voltage is
the same as that indicated on the appliance
rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse
(B). In the event of having to change the fuse in
the plug supplied, a 13 amp ASTA approved
(BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp
socket is a serious safety (shock)
hazard. Ensure that it is disposed of
safely.

Ventilation requirements

The airflow behind the appliance must be
sufficient.
1. Put the freezer in horizontal position on a
firm surface. The cabinet must be on all four
feet.
2. Make sure that the clearance between the
appliance and rear wall is 5 cm.
3. Make sure that the clearance between the
appliance and the sides is 5 cm.
876
1325
665
31
230 - 240
50
11