Table of Contents
Advertisement
GENERAL DESCRIPTION ctd.
1. Backrest
There are two types of backrest fitted to the wheelchair, either fixed or
adjustable. The adjustable backrest can be folded down by means of a locking
mechanism fitted to both sides of the lower part of the backrest pillars. To fold
the backrest down, push on both of the black plastic levers, then pull back and
down on the top part of the backrest. To return to the original, reverse the
procedure, making sure the mechanisms are locked securely.
2. Handles
The handles are designed for the helper to propel the wheelchair. They must
not be used solely for lifting the wheelchair over obstructions or kerbs (see
negotiating obstacles)
3. Armrest
PVC pads are fixed onto the armrest for comfort and can be replaced as spare
parts.
4. Seat Upholstery
Periodically check the upholstery for signs of tears or sagging. Replace
immediately if the seat is damaged. Remember: the seat upholstery is the
primary weight – supporting material.
5. Footplates
The footplates are intended as a foot support only when you are sitting in the
wheelchair. On no account should you stand on the footplates. The heel loops
or calf straps (if fitted) can be used to secure the position of the feet. The
footplate assemblies can be adjusted in height by loosening the nut of the
base of the adjustment tube, positioning the plate at the required height and
tightening the nut to secure the assembly.
The footplate supports cannot be adjusted but are moveable from the
wheelchair. They can be swung away to the outside of the wheelchair. To carry
out this procedure, press the release lever and swing the support to the
outside of the wheelchair. If the support is to be removed, lift it upwards. To
re-fit and return to the original position, reverse the above procedure.
Assembly and Operating Instructions
12
Ver. 4 01/14 (2289)
Advertisement
Table of Contents
