Page 1
3 7 63 1515 0 SERVICE MANUAL L 13942296513 COMPACT DISC PLAYER BASIC CD MECHANISM : DA23LH • This Service Manual is the “Revision Publishing” and replaces “Simple Manual” XP-R220 (AU), (S/M Code No. 09-012-442-6T1). u163 S/M Code No. 09-013-442-6R1 http://www.xiaoyu163.com...
http://www.xiaoyu163.com PROTECTION OF EYES FROM LASER BEAM DURING SERVICING 3 7 63 1515 0 This set employs laser. Therefore, be sure to follow carefully the CAUTION instructions below when servicing. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous WARNING! radiation exposure.
http://www.xiaoyu163.com ELECTRICAL MAIN PARTS LIST 3 7 63 1515 0 REF. NO. PART NO. KANRI DESCRIPTION REF. NO. PART NO. KANRI DESCRIPTION C301 87-016-350-040 CAP,E 470-4 MA GAS C302 87-012-286-080 CAP, U 0.01-25 87-A21-448-040 C-IC,BH6554FV C303 87-012-286-080 CAP, U 0.01-25 8B-HC1-652-030 C-IC,MN101C439-AK C304...
Page 5
http://www.xiaoyu163.com 3 7 63 1515 0 REF. NO. PART NO. KANRI DESCRIPTION REF. NO. PART NO. KANRI DESCRIPTION C712 87-A10-353-080 C-CAP,U0.22-10KB C828 87-A10-260-080 C-CAP,U 0.1-16 K B C713 87-010-831-080 C-CAP,U,0.1-16F C829 87-010-785-080 C-CAP,U0.015-25BK C714 87-A11-062-080 C-CAP,S 2.2-16 Z F C830 87-010-785-080 C-CAP,U0.015-25BK C715...
Page 18
http://www.xiaoyu163.com IC DESCRIPTION IC, MN35530 3 7 63 1515 0 Pin No. Pin Name Description DVDD3 DRAM interface power (terminal No. 2 to 19). 2 ~ 3 D0 ~ D1 DRAM data input/output signal 0 ~ 1. DRAM write enable signal. NRAS DRAM RAS control signal.
Page 20
http://www.xiaoyu163.com IC, MN101C439-AK 3 7 63 1515 0 Pin No. Pin Name Description 1 ~ 7 Not connected. Micro-computer power voltage (2.8 V). OSC2 Not used. OSC1 Main clock oscillator (8.4 MHz). Micro-computer GND. Sub clock input. (Connected to GND) Sub clock output.
Page 21
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description MUTE Audio mute output. Not connected. DSCHRG Electric discharge output. CHRG Electric charge output. Not connected. LCDRDO LCD remote control output. (Not used) Not connected. Not connected. SWDOOR Door switch. 1/13 Not used.
Page 22
http://www.xiaoyu163.com IC, HD6433863A71W 3 7 63 1515 0 Pin No. Pin Name Description BATT-LEVEL BATT level input for battery level indication. AVSS – Analog GND. – Connected to GND. – Not used. – GND. XTAL2 Connection terminal to oscillator terminal. XTAL1 Connection terminal to oscillator terminal.
Page 23
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description AM STEP (10k/9k) AM STEP (10k/9k) switch input. “H” : 10k, “L” : 9k. EX / DO EX / DO. “H” : Export, “L” : Japan. BHC-1 / B BHC-1 / B.
Page 25
http://www.xiaoyu163.com ADJUSTMENT < TUNER SECTION > 3 7 63 1515 0 6. FM Tracking Adjustment 1. Clock Adjustment Settings : • Test point : TP3 (FM-IF) Settings : • Test point : TP2 (OSC) • Adjustment location : L804 • Adjustment location : L901 Method : Set to FM 98.0MHz and adjust L804 so that the test Method :...
Page 26
http://www.xiaoyu163.com CD TEST MODE 3 7 63 1515 0 S101 OPEN/CLOSE SW LAND L 13942296513 TEST LAND IC301 u163 – 26 – http://www.xiaoyu163.com...
Page 27
http://www.xiaoyu163.com 3 7 63 1515 0 The servo circuit of this model is designed to be adjustment-free and the adjustment value and disc distinction (CA-DA, CD-R and CD-RW etc.) is adjusted by within the IC. Therefore the adjustment is performed by each TOC reading. The adjustment conditions within the IC of each servo can be monitored in this test mode.
Page 28
http://www.xiaoyu163.com 3 7 63 1515 0 3. Confirmation of sled movement By pressing the F. SKIP or B. SKIP button continuously when all LCD light up, it is possible to transfer the pick-up to either the outer circumfer- ence or the inner circumference (the LCD is to remain all light up). 4.