Adding Salt - Currys Essentials CID45B13 Instruction Manual

Adding Salt

If the water in your area is hard, deposits will form on your dishes and
utensils. This appliance contains a salt reservoir for you to reduce the
hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir. It
must be set to correspond to the water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Fill the reservoir with approximately 500ml of water (first use only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt. Quantity required
may vary depending on the brand used.
5. Clean any excess salt from around the reservoir opening and then
screw the cap on again firmly.
6. Run the "Rapid" wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt from the
compartment.
• The salt warning light will illuminate when the reservoir
is running out of salt and requires re-filling.
• After filling, the salt warning light will cease to
illuminate within a few days depending on how quickly
the salt dissolves.
open
open
open
21